You pull your favourite dress out of the wardrobe and it looks like it has spent the night screwed up in a bag. You are leaving in twenty minutes. The good news is that most dresses do not need an iron at all. Creases are just fibres that have set in the wrong shape, and a mix of moisture, gentle heat and gravity will relax them again.
Below are seven ways to get wrinkles out of a dress without an iron, starting with the most reliable and finishing with the emergency fixes. We also cover which method suits which fabric, because what works on a cotton sundress can ruin a satin slip.
Check the care label first
Before you reach for any heat, look at the label sewn into the side seam. It tells you the fibre content and the maximum heat the fabric can take. A dress marked 100% cotton or linen will cope with almost anything on this list. Silk, satin, viscose and anything with sequins, beading or a printed finish needs a gentler approach. If the label says dry clean only, stick to steam held a little away from the fabric and skip anything that makes it wet. Our guide to what fabrics can be steamed goes through the common fibres one by one.
1. Use a handheld clothes steamer
This is the quickest way to get a dress looking pressed while it hangs. Steam softens the fibres and the weight of the dress pulls the creases out, with far less risk of shine or scorch marks than an iron.
- Hang the dress on a sturdy hanger from a door frame or curtain rail, somewhere you can walk around it.
- Fill the steamer and let it heat up. The f20 Handheld Clothes Steamer Pro with Suction is ready in about 30 seconds.
- Start at the top and work down in slow, vertical strokes. Hold the hem lightly with your free hand to keep the fabric taut.
- Do the bodice and sleeves from the inside where you can, then the skirt panels from the outside.
- Leave the dress hanging for five to ten minutes so the fabric dries and sets before you put it on.
The f20 has a trick that suits dresses well. Gentle suction draws the fabric onto its 160°C plate and holds it there, so you get a crisp, pressed finish on cotton bodices, pleats and collars with one hand, still on the hanger. It has two steam settings, so you can turn it down for lighter fabrics, and each tank gives about eight minutes of steam, which is plenty for a couple of dresses. In the UK, the f10 Handheld Clothes Steamer is another good option. It is a Which? Best Buy, weighs about 900g and has Full Power and Eco modes, so you can go gentle on chiffon and turn it up for a heavier cotton. You can compare both in our handheld clothes steamers range.
2. Use an upright steamer for long and full dresses
Maxi dresses, full skirts and bridesmaid dresses have a lot of fabric to cover. An upright steamer with a larger tank saves you stopping to refill. The f1200 Clothes Steamer Pro has a 2200W heater, heats up in 35 seconds and holds 3 litres of water for continuous steam from neckline to hem. If you are not sure which type suits your home, our comparison of handheld vs upright steamers sets out the trade-offs.
Whichever steamer you use, the water matters. Hard tap water leaves limescale that can eventually spit on to fabric. Our guide to the best water to use in a clothes steamer explains when filtered or distilled water is worth it.
3. Hang it in a steamy bathroom
If you have no steamer, your shower can do a rough version of the same job. Hang the dress on the back of the bathroom door or a rail well away from the spray, close the door and window, and run the shower on hot for ten to fifteen minutes. Leave the dress in the steam for a further few minutes, then smooth the fabric down with your hands and let it dry before wearing.
This works best on light, loose creases in cotton, jersey and viscose. It will not shift deep folds, and it is too wet for silk or anything dry clean only.
4. Smooth it with a damp towel
For a single crease across the skirt or a fold line from the shop, lay the dress flat on a bed or clean table. Dampen a hand towel so it is barely wet, then press it over the crease and smooth outwards with your palms. Hang the dress straight away and let gravity finish the job. A light mist from a clean spray bottle works too.
5. Use a hair straightener on small areas
A hair straightener is handy for collars, straps, cuffs and the edge of a hem. Wipe the plates clean first so no hair product transfers to the fabric, set it to the lowest heat and test on an inside seam. Clamp briefly and keep it moving. Avoid it on synthetics, silk, sequins and anything with a printed finish, because the plates get much hotter than a steamer and can mark the fabric in a second.
6. Try a hairdryer
Hang the dress, mist the creased area lightly with water, then dry it on a medium setting from about 10cm away while you gently pull the fabric straight. It is slow, so keep it for small patches.
7. Use the tumble dryer, if the label allows
For cotton and polyester blends that can be tumble dried, put the dress in the dryer with a damp (not soaking) flannel for ten minutes on a low heat. The moisture turns to steam inside the drum and relaxes the creases. Take it out as soon as the cycle ends and hang it immediately, or the creases will set again. Never do this with silk, wool, viscose or anything embellished.
How to treat different dress fabrics
- Cotton and linen: handle plenty of steam and heat. Use the higher steam setting and the pressing plate for a crisp finish on collars and pleats.
- Jersey and viscose: creases drop out fast with light steam. Do not pull hard while the fabric is warm, as it can stretch.
- Silk and satin: use low steam held just off the surface and work from the inside to avoid water marks. Our step-by-step guide on how to steam silk covers this in detail.
- Chiffon and tulle: very light steam from a distance, with the skirt layers separated so each one hangs freely.
- Sequins, velvet and beading: steam from the inside only and never press the plate onto the outside. Our party outfit care guide explains how to handle each one.
Stop the creases coming back
Hang dresses on wide, shaped hangers with a little space either side, and fasten the top button or zip so the neckline keeps its shape. If you are travelling, roll rather than fold, and pack the dress last so it sits on top. Our guide to packing so clothes arrive crease-free has more tips, and a small handheld steamer in your case fixes anything that still gets creased on the way.
Frequently asked questions
What is the fastest way to get wrinkles out of a dress without an iron?
A handheld clothes steamer is the fastest option. It heats up in under a minute, works while the dress hangs and removes most creases in a few minutes. Work from top to bottom in slow strokes, then leave the dress hanging for five to ten minutes so it dries and sets before you wear it.
Does hanging a dress in the shower get rid of wrinkles?
It helps with light creases in cotton, jersey and viscose. Run a hot shower for ten to fifteen minutes with the door closed and the dress hanging away from the spray, then smooth it with your hands. It will not remove deep folds, and the moisture is not suitable for silk or dry clean only fabrics.
Can you steam a dress that says dry clean only?
Often, yes. Many dry clean only dresses can be steamed gently, because steam held a little away from the fabric adds very little moisture. Use the lowest setting, test on an inside seam first and work from the inside where possible. Avoid anything that soaks the fabric, such as damp towels or the shower method.
Is it safe to use a hair straightener on a dress?
It is fine on small areas of cotton or linen, such as straps, collars and hems, if the plates are clean and set to the lowest heat. Keep it moving and test on a hidden seam. Do not use it on silk, satin, synthetics, sequins or printed fabrics, as the plates can scorch or melt them quickly.
